...
| Widget Connector | ||
|---|---|---|
|
Operation Checklist
- Turn on powder booth vent, and also the filter on top of the oven
- Verify powder container has about half a container of powder, and connect to the powder coat gun
- Attach the air compressor hose to "pressure chamber", and ensure the hose is not hanging from the device
- Attach and ground the part (copper wire to part if needed
- Spray the part while holding the trigger from a distance of 8 to 16 inches away
- Make sure part is fully and evenly coated
- Bake parts in the oven for 10 minutes after the oven reaches 400 degrees (ensure not to touch and knock paint off)
...