• Wire Management and Strain Relief
  • Cut wires to length (keep in mind the additional length in ports)
  • Don't overstrain the wires
  • All wire runs must be secure and protected from moving components
  • Put zip ties so the wires don't hang, but don't add any strain
• Labeling
  • Label all wires with the gold label maker 
  • Add a label in the middle where it is easily seen and on the end
• Choose secure connections
  • Prioritize ring connectors (at krakens) over putting several CAN wires in one port
• Torxing
  • Make sure the Krakens are torxed down tightly to ensure it doesn't come out of connectors in the ring terminal